Furrion 12v fridge

[Tomw22]

I have a 2021 Eagle HT 28.5 RSTS Fifth wheel, I have lost power to my 12v Furrion fridge. Fuse is good. I have good ground at back of fridge but no 12v. If I put 12v to back of fridge It will work. Is there an inline fuse I can’t see? Because it appears the fuse in the converter doesn’t power the fridge. Jayco was nice enough to send me diagrams but nothing with wiring schematics. The dealer was less than helpful.

[Russc25]

Sounds like the wire is broken and you need to trace it to repair/re-run. Start at the back of the fridge or the back of the power center, you'll have to follow it through the basement, under the trailer, and the slide harness.

For that matter, start at the power center, make sure the wires are all tight there. Lots of cases on here and elsewhere of connections working loose and needing tightening.

[Markb5900]

Originally Posted by Tomw22

I have a 2021 Eagle HT 28.5 RSTS Fifth wheel, I have lost power to my 12v Furrion fridge. Fuse is good. I have good ground at back of fridge but no 12v. If I put 12v to back of fridge It will work. Is there an inline fuse I can’t see? Because it appears the fuse in the converter doesn’t power the fridge. Jayco was nice enough to send me diagrams but nothing with wiring schematics. The dealer was less than helpful.

I don’t know where it is, but my dealer had told me there’s a fuse or reset in the back of the fridge by the board.

[DStout]

I experienced this issue on the 12v Furrion fridge in my 2021 Whitehawk. After much research, I found their is a glass inline fuse behind the rear panel of the refrigerator. I was able to find one at my local parts store and then ordered spares from Amazon to have on hand. I plan on updating this to a regular blade automotive fuse and do away with the glass fuse. Hope this helps.

[normbb]

I had the same issue with my 2021. The glass fuss was wrapped up in the wire bundle behind the outside refrigerator panel. Jayco replaced it with a blade fuse, (not wrapped up in the bundle), as part of what I think was a recall. At least I didn't pay for it being done by my dealer.