Generator install for a eagle

[Mopar_Earl]

Just remembered, my trailer is not home. It's parked at an upcoming event later this week. I will look for the receipts later this week when. I get to the camper.


Earl

[Mopar_Earl]

I recommend using exhaust sealer paste on the connections to help make them completely sealed. I looked at my pics. Looked like I used two adaptors. I may of used 1.25" pipe. I will have to look at the trailer.
I used exhaust t-bolt band exhaust clamps. I don't like U-bolt clamps.


Earl

[tec]

Thanks again for all your help.

[tec]

Well got exhaust hooked up, not exactly where I want it but within tolerances until I get the parts I ordered. So hooked everything up, wired black to black, black with stripe to red, whites together, green to bare copper, and nothing, no power. Am I missing something? Unit is grounded by the installation? Do I need to ground it differently?

[Mopar_Earl]

No output or no cranking? You run a 12v ground cable to the battery? 12v positive to the battery?

If it's running with no output, are the genset breakers on/closed?

Earl

[tec]

Everything was set right, I just didn’t give it enough time to kick in I guess, it’s working great now

[Mopar_Earl]

Ok, yeah the transfer switch has a bit of a time delay before pulling in. Allows the genset to stabilize before being loaded.


Earl