|
There are other post on what I think is the issue here. I am not that familiar with the Haloview camera system but I assume it is similar to the Furrion system. The left and right marker light was replace with the camera. Everything works fine until the turn signal is selected.
The marker lights are usually wired with two wires, a power and a ground. With the JaySmart light system there is a control box, usually mounted behind the propane bottles, that will cause the marker lights/running lights to blink when the respective signal is selected. It will intermittently interrupt the power to cause the light to blink. The same happens with the camera. When the signal is selected power is removed from the camera and the screen goes blank. When deselect it goes back to normal.
The resolution is you will need to run another power wire to each of the lights to provide a constant 12 VDC. This will keep the camera powered all of the time. I have seen other post that supply alternative methods using relays in the circuit but I'll let someone else address that.
Hope that answers your question. If I find the other post I'll provide a link.
__________________
Keith and Lisa Ward
2019 Pinnacle 36FBTS
2021 Ford F350 XLT CC LB DRW 6.7L Diesel
Demco 18K Autoslide Hitch and Timbrens
2019 Ford F350 SB 6.7L Diesel (Gone)
|
Linear Mode
