Kitchen slide issue

[JeanBean70]

Lol. Thank you.

[JeanBean70]

Hahahaha. Thank you truly for your help.

[RoadrunnerII]

Originally Posted by JeanBean70

Hahahaha. Thank you truly for your help.

Something for the next time you have to look up above your bifocals.. Buy a cheap pair of cheater glasses. They magnify up, down out in front. Then looking up inside a cabinet is a little easier.. That and a really good head lamp flashlight.

Smiles
RoadrunnerII

[Poppyof5]

So is the reset in the under sink cabinet, over the sink vanity or the over the sink cabinet.???

[JeanBean70]

Originally Posted by Poppyof5

So is the reset in the under sink cabinet, over the sink vanity or the over the sink cabinet.???

There is no rest button for the kitchen slide the side with the fridge. It’s a different system. It will give you error codes but you can’t reset it. It’s located in the bottom cabinet in the half bath, up high ion the far back right corner in the skinny space just above the shelf.

[Poppyof5]

Originally Posted by JeanBean70

There is no rest button for the kitchen slide the side with the fridge. It’s a different system. It will give you error codes but you can’t reset it. It’s located in the bottom cabinet in the half bath, up high ion the far back right corner in the skinny space just above the shelf.

Well thats good to know. Whats the fix ?

[kirkelli]

I had a problem with bedroom slide the first day I purchased the RV. I called the dealer for help, they instructed me unplug shore power and the battery disconnect of for 30 second and back on. It fixed the issue. Had to use same sequence on one other occasion. I guess shutting power off is the same as a reset

[JeanBean70]

There was some type of loose wire. We are not exactly sure. Both motors were taken off and tested. All connections to batteries and modules were tested. Everything checked out ok. The act of disassembling and reassembling both motors titghtened up whatever was loose, and the slide works again.

[Radar57]

Originally Posted by JeanBean70

There was some type of loose wire. We are not exactly sure. Both motors were taken off and tested. All connections to batteries and modules were tested. Everything checked out ok. The act of disassembling and reassembling both motors titghtened up whatever was loose, and the slide works again.

It could have been a loose connector at the motor and messing with it could have secured it. On the controller location I think they dangle that in mid air and the build everything else around it.