Light above table?

[dpica15]

Finally brought my new Eagle home. Upon checking everything out,one of the lights above the kitchen table doesnt work. I was going to check the bulb, but i cannot figure out how to remove the glass lens. If anyone has that style of fixture, can they try to explain how it comes out. It is a new style fixture ( big oval wooden with mirror on it).

[3'senough]

A picture might help us decipher. Is it a flush mount?

[dpica15]

Your right i should of added pictures
Here they are

[WVDusty]

Mine are like that all i had to do was get ahold of the edges and pull down and side to side. Hope that makes sense. I had the same problem when we brought ours home turned out it was just a loose bulb.

[Tunce the traveler]

It's a friction fit.

[dpica15]

Ok thanks....i will try tomorrow

[namusmc65]

I have the same fixture in my 33.5RETS. You just have to get a fingernail under the edge and work it down. Can be kind of snug. Also had problem with that bulb as well. Just re-set it and it worked fine. Same bulbs over the fireplace did the same thing. They don't seam to seat very well in their socket and work loose with all the bouncing around.

[Eagle2014]

Have taken both of mine out, cleaned, reset, jiggled, etc. numerous times. They'll work the first time and then refuse to come back on until removing and doing the same thing again. Get's old fast and a real pain pulling the lens off each time. Have given up. Anything I can do to make them work?

[maromeo]

We had an issue with the light working intermittently. DH took the switch apart and found loose wiring and replaced the wire connectors and all has been working fine.

[ont-tt]

They look very similar if not the same as the ones in my unit, I had to unscrew them I was looking to check to see if I could replace the bulb with a lower wattage, looks like they are hard wired, not a socket type bulb, you may want to try and unscrew it before you pry it off.

[Sea Six]

Sounds like a bad connection to me.

[namusmc65]

I have had to pry mine down so many times to re-seat the bulb that the glass lens has started chipping! Seems like after a long bouncing trip the same bulb does not come on until you re-seat it!