NP 377 Dining Slide Binding On Open

[prm99v6]

My dining table/loveseat slide binds when opening on the top of the slide. It’s like it gets stuck, the motors strain and then it “pops” loose and finally starts moving. I’m thinking it’s adjusted to high and that I should loosen the bolts, and adjust then jack screw on each side to lower the box a little. It sits flush on all sides (top and bottom, left and right) against the wall when closed and does open fully once open. It just sticks on top when opening and causes a lot of strain on the motor. Can someone confirm this thinking.

[Springhook]

I'd suggest opening it halfway,, then check the clearance at the top of the slide from the inside. Should have equal clearance all the way across. Not sure how much clearance, but "some" clearance for sure.

[prm99v6]

I ended up resetting the zero on the ground control 3.0 and it helped a little. I am actually thinking the residual issues are just the seals sticking. I do use seal conditioner and as far as I can along the top seal but with a slide topper it’s hard to get full coverage. Measurements are all good.