Satellite to all TVs

[Jace817]

I have a 2019 377 RLBH and I am trying to figure out the best way to send a single satellite box to all TVs. What I’d like to do is have the box at the main tv in the living room where I can hook the HDMI up to the large TV. I also have an RF modulator to send the signal over coax to the rest of the TVs, but it doesn’t look like it was wired that way.

I found the coax splitter behind the utility dock. My question is, is there coax run from the living room TV to this area or the other TV’s?

Is there a better way to do this? CAT 5 is the only other way I can think of, but I’m not sure how to get to the rest of the other TVs.

[43acres]

I wrote an exact description of this. Search for the thread by user 43 acres. I believe I titled it "satellite wiring solved". Let me know if you don't find it

[REWahoo]

Here's the post:

Originally Posted by 43acres

I finally figured out my satellite wiring on my 315 and thought I would share.

We have a dish receiver in the living room and I wanted to watch satellite on all the TV's, realizing it would have to be the same channel on all three TV's. I disconnected the TV wire in the cabinet above the living room TV and use that connection to run satellite to all TV's. I connected an RF modulator to the receiver (sat. out) with a rg6 coax and then connected the RF modulator to the TV connection with another rg6 coax. I get a perfect picture on all three with this set up. I had a couple satellite IR cones from a previous satellite system and use that to change channels on the bedroom television when we are in there. Hope this helps someone out!