Slide out help

[5Castles]

I had trouble retracting the door side bunkhouse slide on a 2017 North Point 375bhfs I manually overrode it. Once I arrive at my destination, I tried to override it to extend it, and no luck. Any help would be much appreciated. Thank you in advance.

[Rustysocket]

Your best source of information is directly from lippert. There website has a lot of good guides on it, albeit sometimes difficult to navigate. Especially if you are frustrated.

I was just on there looking up some information on the Schwintek slides myself.

The website is Lippert Components the leading OEM and Aftermarket RV Parts and Accessory Supplier

Which slide are you having trouble with on your unit. What lights are you getting on the controller?

[5Castles]

Im getting a red and green both flashing on the module. It is the door side bunkhouse slide, with the outdoor kitchen. Thank you

[Rustysocket]

Originally Posted by 5Castles

Im getting a red and green both flashing on the module. It is the door side bunkhouse slide, with the outdoor kitchen. Thank you

I can't really help you specifically, but If I recall the green light will flash to indicate which motor (either 1 or 2 blinks) and the red light will flash a number of times to indicate the error. There is a label on the top of the controller with the error counts.

Let us know what you find out.

[Mopar_Earl]

The lights are for trouble codes. Go in Lippert support site and pull up their troubleshooting guide to understand how to read and interpret the codes. Also it will tell you how to over ride it and how to manually open and close it as well. Lots of cool reading on their support pages. Also there are YouTube videos as well.


Earl

[3'senough]

Originally Posted by Mopar_Earl

The lights are for trouble codes. Go in Lippert support site and pull up their troubleshooting guide to understand how to read and interpret the codes. Also it will tell you how to over ride it and how to manually open and close it as well. Lots of cool reading on their support pages. Also there are YouTube videos as well.


Earl

As stated above the number of flashes tells you the error. Count and read the chart on the module to give you the issue. I had a wire tear on one of the BH slides 2 years ago.

[bdreinv]

Check U Tube also are several good videos from Lippert!Lippert tech support 574-537-8900!

[5Castles]

Thank you guys!! I unpluged the relay at the fuse panel, plugged it back in and that reset the module. I was able to extend the slide all the way out. Now the residential fridge only runs off of the inverter. Any more ideas lol

[Grumpy]

Originally Posted by 5Castles

Now the residential fridge only runs off of the inverter. Any more ideas lol

Sounds like a tripped breaker or GFI.

[5Castles]

I tried the GFCI, fuses, breaker and to no luck so far

[Grumpy]

There is also a reset on the side of the inverter, give that a try.

[5Castles]

I located a black button on the side of the inverter,only button I found on the inverter. It was not tripped. Is that the one I was looking for or did I miss it?

[Grumpy]

Did you push it? Don't think it actually looks tripped.

[5Castles]

Yes I went ahead and pushed it, just incase.

[Grumpy]

Do all your other outlets work?

If it works with the inverter on there are 4 possible issues. Tripped breaker, tripped GFI, loose wire going to the ac in side of inverter or bad internal transfer switch in inverter.