Seneca Direct TV

[Foster15]

Morning. After several months I am now getting to setting up Direct TV on our 2015 Seneca 37TS. We have the Traveler SWM antenna on the roof and the entertainment center option over the cab. The antenna powers up and interface box indicates the 3 satellites are found.

The problem I am having is with the cabling from the antenna. There are supposed to be two wires/cables from the antenna. One goes to the interface box; that is obviously there and working properly. What I cannot see is the coax. There is a coax face plate on the wall inside the entertainment center with two threaded male coax ends. Face plate is labeled "roof sat" and the two threaded ends are labeled LNB 1 and LNB 2 input. Should I pull the face plate and look to see if cables are there or can I assume one or both have the coax attached? I do not want to fry something. I have left the power to the antenna on but do not believe I need to once satellites have been found. Thanks. Foster 15

[magicmarker]

LBN1 has the coax connected to the back already. Plug your coax from receiver into LBN1

[Foster15]

Thanks Magicmarker. I did use the input #1 and it worked fine. I see there are two coax cables (besides the one going to the front TV in the entertainment center) one marked with yellow tape and one marked with blue tape. The cable with the yellow tape goes to the bedroom TV. I would think the blue marked cable goes to the outside TV but I cannot locate it. I removed the TV and bracket to look behind the TV; no cable to be found. Any ideas?


Foster 15