2012 29RLDS manual operation

[joe in calif]

I'm looking for information on how to manually operate the slides on my 29RLDS in case of a failure of the motor. I looked at the owners manual and it shows a bolt to turn but the picture is so close to the bolt it does not show where the bolt is located. I look underneath the trailer, it has the insulation on it, and I can't see any inspections areas where I might access the motor. Any help would be greatly appreciated
Thank You

[33 RLDS]

My 33 RLDS has the thermal package but has a square piece cut out screwed into the thermal cover wherever the access points are for my 3 slides. You would need the square driver(or a small enough flat blade) to remove the screws to gain access..

[arkhillbilly]

I have a 2012 298rls and the cut out for the slide motor is between the frame beams, left side of slide, facing rear door. The motor should be located there. Oh, opposite side of unit from the slide.

[joe in calif]

Thank you for the replies, I will check it out

[joe in calif]

Originally Posted by arkhillbilly

I have a 2012 298rls and the cut out for the slide motor is between the frame beams, left side of slide, facing rear door. The motor should be located there. Oh, opposite side of unit from the slide.

Thank you for that, do you know where the motor for the front, wardrobe slide, is located?