another Schwintek slide question

[SuckyFisherman]

2021 184BS. My slide would not go out, it would start and then the left side motor would stop. I pushed the manual override button, They are now blinking red and green.

The slide is now working fine . Did i resolve the issue or is only working in an override mode. Is them being out of sync a sign of another problem that will occur when Im not at the comfort of my home

Im just find it hard to believe i fixed the problem by pushing a button 7 times and a little bit of swearing

[Nature Ist]

I'd be very surprised if the problem fixed itself, or you fixed it. My first guess is you may have an intermittent short or wire that has a poor connection. Did you read the number of flashes to determine what the code indicated the problem was before you tried to over-ride it? If not, next time it happens, count the flashes and determine what it indicates. That will get you started on troubleshooting.

[SuckyFisherman]

You are correct, My success was short lived, and I was able to to get the code. Its a short between the controller and motor. Its working now but I guess I will start to figure out how to find the short

[ScoobyMike]

Motor wires likely pinched in the H column. Look at top of H column on the inside side.