Ok so if this is dumb let me know.
I’m upgrading to a 5 in 1 antenna to go with a router.
It’s very light n quite small.
I don’t want to drill a big hole in roof
Could i mount it to my roof fridge vent?
Then I could get some big washers n screw it in n dicor it
Then I could runs wire in.
Lots of folks run wires thru fridge vent
BUT would there be any issues you think with heat and electrical interference by actually mounting this little antenna ON TOP of the vent?
Looks like your tt has a frig roof vent. Skip the drilling completely. Up through the wire mesh, out under the vent cover. Remove on roof vent screw. Make a simple met bracket for that location. Put the screw back in. Should attached to a good reinforced location.