Rookie RVer here. Recently purchased a 2018 Jayco Eagle 306 RKDS. Spent two month @ Camping World to get a stabilizer fixed. Set up in Deming, NM. Stove and furnace wouldn't fire up. Pulled tanks to check. Replaced and both worked for 24 hours... once again not firing up. Line issue? Regulator? Fortunately, I have electric furnace. Thoughts?
Try this:
Turn off your tanks. Remove the propane hoses from the regulator, leaving them attached to the tanks. Once that's done, slowly open the tank valve. Now, do you have a good flow from the tank? Do this for each tank.
I had a regulator fail once on a brand new camper. By performing this test I was able to tell that the tanks were flowing but the regulator was bad. A new regulator did the trick.
There are high flow shut off valves in the pigtails also. I had one fail a few years back and it took me forever to figure it out. I replaced both of them and not one issue since.
. Advice to a rookie. Live by Camping World, die by Camping World.
Linear Mode
