Go-power control module

[lock65]

We recently purchased a new unit that is prepped for solar , My question is where the sticker on the wall is for the Go-power module do the wires just run past this point or are they terminated at this point?I don't want to cut the wall to find out that the wires go uncut from the roof to the battery.The reason I am asking is the controller I have is surface mounted so want to mount in the cargo bay.Yes I could run a wire and do a continuity test .I was hoping someone would know . thanks in advance

[Shokyle1]

I don't know what you have, but on my eagle ht they were just looped by the sticker. Unfortunately the factory also forgot to hook them up at the roof port. On my in-laws eagle ht the power wire was cut and capped near the sticker the ground was looped. But it was hooked up to the roof port. The easy test is make sure the solar wires are not hooked to the batteries jump the roof port and measure for continuity at the solar wires that hook to the batteries if you have continuity you have the wiring in the wall is solid.

[lock65]

Thanks , that is kind of what i figured nothing is consistent.I will test the wires if they are cut then will by a different controller , if not will mount in storage bay.