Quote:
Originally Posted by devonquest72
Hello all,
I need some assistance please. My furnace will not heat. I have checked the fuse...fine. I have checked the breakers...fine. I have run the fridge, stove and hot water tank on gas...fine. It worked yesterday but quit in the evening. I turn on the wall thermostat and the fan kicks in immediately but turns off after about 30 seconds. Obviously not lighting and then turns self off.
I have an Attwod 8500-IV series. I've checked the only panel outside to reset but only have the hot water tank available in that compartment. I checked under sink and the furnace is there but is completely covered in metal without any access areas. Any ideas how I reset this????I'm in a 2012 28 bhs.
Soooo cold....
Christine
|
Not to take the easy way out here, I have the same TT, just a little newer, and other than having to 'reset' the propane emergency shutoff valve (as described in posts above) no idea. If you search the forum for "Furnace Won't", you'll get a treasure chest of posts, many fairly recent on this exact problem. Unfortunately a lot of people never come back to the post to let us know what fixed their problem, so there are a lot of open ended problem reports. Please let us know if you figure it out, what the problem was.
With all the posts I've seen lately regarding furnace problems, it's probably wise to get one of those small ceramic heaters just as an emergency back up if nothing else, and I know several that use them all the time. Obviously not a fix, but might keep you from totally freezing your butt off in the short term.