Jayco Eagle Floor Replacement

[LethalLimited]

Finally decided to work on the travel trailer to get it ready for the summer.

I started replacing the laminated one piece floor and decided to target a soft spot that developed right by the door on the corner of the slideout.

Anyone know what's the thickness / specs of the plywood used? Haven't pulled it apart just yet until I get the material I need.

Thanks.

Trailer is a 2014 Jayco Eagle 338 RETS

[Greg58]

Mine was 5/8 OSB, I would think yours would be the same or thicker.

[LethalLimited]

Originally Posted by Greg58

Mine was 5/8 OSB, I would think yours would be the same or thicker.

I know for sure mine isn't OSB material. But probably the same thickness.

[Greg58]

I replaced the OSB with plywood, this is on a 165 sport.

[Jagiven]

I would for a hole they used to run electric, propane line, or similar through the floor. Jayco makes huge holes, and take a measurement.

Jayco made something like a 2" hole for where my 7 pin wire harness enters the TT, you might have something like that too.

[LethalLimited]

Originally Posted by Jagiven

I would for a hole they used to run electric, propane line, or similar through the floor. Jayco makes huge holes, and take a measurement.

Jayco made something like a 2" hole for where my 7 pin wire harness enters the TT, you might have something like that too.

Great idea, I'll check it out when I'm home from work.
Thanks!

[Greg58]

I used the best plywood I could find, 4 ply sanded exterior from Home Depot. I painted the underside with oil based black paint before installing.