I installed one on our previous trailer with no problem. On our new 32TSBH, the sewer vent is very close to the bathroom vent. The slot on the front bracket is off of the vent housing. (does that make sense?) Anyone else run into a similar situation?
If you're familiar with the MaxxAir II mounting bracket you know it has a slot to use with regular vents, and two screw holes to use with high powered vents. I was able to use one of the screw holes at the very end of the vent housing. I think it will be fine, but I'll check it every so often to make sure.
TT's breed ingenuity. Seem to recall a similar problem where the TT'er ground a relief to miss the vent. If the vent is square in the way your solution sounds good.
__________________
Cheers,
T_
2013 F-350 CC SB 2WD 6.7PS
2013 Eagle Premier 351 RLTS
-SOLD- 2012 X23B
-SOLD- 2003 Ford Expedition 5.4, Bilstein shocks
Linear Mode
