smart lights not blinking on new 2022 , 224bh trailer

[shockboy]

all the lights light up , regular blinkers and brake lights work. reverse lights work. but, i think the top and side lights are suppose to blink when my blinker (turn signals are on ?

[Learjet]

Originally Posted by shockboy

all the lights light up , regular blinkers and brake lights work. reverse lights work. but, they don't blink ?

reverse lights are not suppose to blink....see demo below.

https://youtu.be/PvsolNajrgU

[ARoamer]

Originally Posted by shockboy

all the lights light up , regular blinkers and brake lights work. reverse lights work. but, i think the top and side lights are suppose to blink when my blinker (turn signals are on ?

On my pinnacle- Only 1 rear of my rear facing upper marker lights blink along with the side marker lights when blinkers are on.
There is a module somewhere that controls that function, maybe malfunctioning or not wired correctly. IF you can find it and they use the same module in yours there is a LED that may help diagnose your problem. Or, just put it on your warranty list.

[Scott]

Originally Posted by ARoamer

There is a module somewhere that controls that function...

On my travel trailer, that module is found in the front pass through storage compartment, driver's side, in a wooden box mounted to the front side of the camper (your left when you open the baggage door). Remove the box and that should review the module in the picture in the post above mine. I have also heard about it hidden in other parts of the camper though. Good luck!

[Learjet]

my bad...ignore my response to reverse lights...I see the problem now.

[EEJayco61]

Find the controller. On my '21 Northpoint, it is above the LP tanks in the driver's side compartment. If you use a camera, you can take a picture of the sides of the contoller. One side explains error codes based on number of blinks. The other side shows wire colors for input/ output.
On mine, the right side lower markers and the right FRONT uppers weren't flashing, but the REAR upper was. The box said the GREEN w/ WHITE STRIPE is output for the suspect markers. I cut off the connector that joined that wire to the two BROWN w/ WHITE STRIPE wires. After I put on a 3M waterproof crimp connector, EVERYTHING works now!

[Spaceguy85]

Originally Posted by shockboy

all the lights light up , regular blinkers and brake lights work. reverse lights work. but, i think the top and side lights are suppose to blink when my blinker (turn signals are on ?

Had this problem with my 2020 White Hawk 32RL. They just stopped working. The dealer tried to tell me that I had no S.M.A.R.T. on my rig. Explained that it worked for about 6 months, then nothing. I called Jayco and verified I had what I knew I had. The dealer had a Jayco Rep come to the shop and fixed it. There was a fuse in the box that was not labeled, which was blown (open) He replaced that, and now they work again.