Slide out bed not even

[Squeaky]

Howdy everyone,

I noticed when setting up last night that one of our beds is not even. When I pull it out, I make sure it's even, but when we attach the supports under and popup the canopy, the left side is a few inches out further than the right (even).

If I try and push it back in and it's all setup, the canopy and everything sags. It almost seems like everything isn't squared up right...

Photo attached.

Dog tax added for appreciation.

[Dubblbubbl]

My guess is the bunk support brackets under the slide out bunk are out of alignment. Measure the distance between the brackets and the end of the bunk and between the brackets and the side. The bracket on the side that has the gap may be mounted a little closer to the camper body than the other. If so adjust their location. Also check to make sure you’re mounting the bottom of the support brace at the correct location on the frame or bumper. Also check the length of the support braces, you may have mismatched braces, if so check the braces on the other bunk to see if you just have them mixed up.