2015 31 DS Slide Manual Operation
I have a 2015 Greyhawk 31 DS and I am trying to find where the "manual override" is for the power gear surface mount dinette slide. I have found the location for the slide motor and can manually unlock the motor brake, but I can't seem to find the 3/4 inch manual override nut, on the drive shaft assembly, to manually crank in my slide. I tried following both ends of the driveshaft, but there are no access panels or ways to reach the ends. Any help will be appreciated. Thanks in advance.
With the drive shaft being square can you just use an open box wrench and use it on the square stock. Might take awhile but I would think that should work.
Sent from my iPhone using Tapatalk
Thanks RVermont. I will give it a try in the spring when I open her up again. cheers.
|All times are GMT -6. The time now is 05:17 AM.|
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Copyright 2002-2016 Social Knowledge, LLC All Rights Reserved.