BMpro

[Arndog-JAY]

Looking for advice on how to tell if the BMPRO in my 2024 Jayco 321rsts is one of the new units without a battery or one that has to have the battery replaced. My is working fine so far, but just want to be prepared if I need to replace the battery. Mine looks like the pic below.

 

[Learjet]

If it doesn't show battery charge level on the top right, then it is new model with no internal battery. ie the 100% in the picture you posted.

 

[Arndog-JAY]

Thanks Learjet, I will have to check my unit. The picture was from the manual I downloaded from BMPRO, not my actual unit.

 

[BigOBoys]

You can call Jayco with your VIN and they will tell you.

 

[krudawg]

Looking for advice on how to tell if the BMPRO in my 2024 Jayco 321rsts is one of the new units without a battery or one that has to have the battery replaced. My is working fine so far, but just want to be prepared if I need to replace the battery. Mine looks like the pic below.View attachment 1113874

View attachment 1113874

So I paid the $500 and upgraded to the battery-less "new" Model. After the season was over and it sat for 8 months. I come back and the display turns off when not in use. The problem is the only way I can get the screen back is remove if from it's mount and pull the plug and then plug it back in. Its a PITA. You would think for $500 the damn thing would be flawlesss but oh no

 

[jetlag]

So I paid the $500 and upgraded to the battery-less "new" Model. After the season was over and it sat for 8 months. I come back and the display turns off when not in use. The problem is the only way I can get the screen back is remove if from it's mount and pull the plug and then plug it back in. Its a PITA. You would think for $500 the damn thing would be flawlesss but oh no

I am at a loss as to what is happening but it does not sound right. I would contact BMPRO

 

[ClarkeNorman]

There is a reset button located through a paper-clip size hole just to the right of the RET button. You have to look up to see the hole. Press the paper-clip up into the hole and hold the button for a long press. You will be presented with a menu to reboot the panel, which is exactly what you're doing when you remove and replace power.

 

[krudawg]

I will check that out. Thanks

 

[Learjet]

There is a lot of trouble shooting information here JAYCOMMAND Powered By BMPRO - Smart RV System | BMPRO

 

[krudawg]

Great info thanks

 

[krudawg]

There is a lot of trouble shooting information here JAYCOMMAND Powered By BMPRO - Smart RV System | BMPRO

There is no reset button on mine. I spent 20 minutes pushing a paper clip into the hole and never felt it was pushing on a micro-switch. Mine is the new one without an internal battery that replace the one that was installed when new

 

[Learjet]

I have a new one and it still has a reset. You have to push up through the hole at a slight angle and hold it for a few seconds, then you should see a menu pop up to restart or reset. You are pushing a button on the side of the tablet inside the housing.

 

[krudawg]

I finally removed the thing for the wall and found it. It reset and woke up then after about 5 minutes went dark again.

 

[mavrick0]

I finally removed the thing for the wall and found it. It reset and woke up then after about 5 minutes went dark again.

Does the screen come back on if you double tap it? If so then it's going into a power save mode or screen saver which should be a simple setting change on the tablet.