Can't find the bolts

[redneck51]

I guess I need HELP,
Where are the dual recliners bolted down in an 2022 Pininale rlts? I've rocked them all over and don't see the anchor bolts. My next move is to find a bigger crow bar and get rough. Anybody know?

 

[Grumpy]

I guess I need HELP,
Where are the dual recliners bolted down in an 2022 Pininale rlts? I've rocked them all over and don't see the anchor bolts. My next move is to find a bigger crow bar and get rough. Anybody know?

If they're mounted like they were in our 38FLSA there are screws in the front cross bar, which is accessible once you have the leg rests extended. The back was held in place with "Z" brackets and the rear cross member just slid under them.

 

[redneck51]

So far it's not in the front cross bar, I can lift them up and see daylight under all bolts. and checked for any other screws in it.

 

[ShepVA]

That is funny, you cannot get your recliners to come out and we cannot get ours to stay put. The recliners in our pinnacle have never wanted to stay where they belong and slide out of position almost every trip.
Grumpy is right there is a metal Z bar in the back and it may have you caught. if the front lifts up you want to pull forward and it will slide out of the brackets.
Just be careful once you have it loose it may not want to stay put again......

 

[Kevin Cooper]

That is funny, you cannot get your recliners to come out and we cannot get ours to stay put. The recliners in our pinnacle have never wanted to stay where they belong and slide out of position almost every trip.
Grumpy is right there is a metal Z bar in the back and it may have you caught. if the front lifts up you want to pull forward and it will slide out of the brackets.
Just be careful once you have it loose it may not want to stay put again......

So, are you saying all your screws came out and you didn’t put them back? If the holes are wallowed out, slide the recliners out to have access to the holes, stuff them with cotton, and put super glue on the cotton. Repeat this until the enlarged hole is filled. Mark your holes, and drill out smaller than your screws and reinstall.

 

[ShepVA]

Yes it is totally my fault that it is moving around.
The screws came out when I picked it up, I guess they were never put in correctly or at all from the factory and I never found them.
I put some short screws in it as I was afraid it might get into the floor as the slide comes in if it was too long (and it is what I had on hand) and of course they are pulling out and the recliner goes for a trip.
So I need to find the correct length screws at the hardware store and the problem will be solved, but it has not made it to the top of the list yet......

 

[Kevin Cooper]

You might want to put three of these in and have some spares.
https://a.co/d/iXCboWb

 

[ShepVA]

That is a good idea,
Thanks for the link