Thanks to this site I read about a great way to store the Rino hose and adapters. Almost made it to short, but it works. I used the 5x5 vinyl fence post, and a section of 4" vinyl gutter as read about here.
I glued thin pieces of hard wood plywood where I would be drilling some holes and used 1/4 x 1 1/4 inch washers to spread out the load where I attached to the frame. Drilled some holes in the bottom in those locations to get access to the bolt heads. Also had to put a piece of treated 3/4" plywood between the frame and the vinyl post to space it down a little. Plus a little black paint.
I used a piece of treated wood to create the removable end cap. Installed some brass inserts and put a washer and lock washer on the knobs.
Here's some pics.
Again, thanks all.
I glued thin pieces of hard wood plywood where I would be drilling some holes and used 1/4 x 1 1/4 inch washers to spread out the load where I attached to the frame. Drilled some holes in the bottom in those locations to get access to the bolt heads. Also had to put a piece of treated 3/4" plywood between the frame and the vinyl post to space it down a little. Plus a little black paint.
I used a piece of treated wood to create the removable end cap. Installed some brass inserts and put a washer and lock washer on the knobs.
Here's some pics.
Again, thanks all.