Frame question

[DaveT-JAY]

I'm moving from EZ Lift weight distribution and sway bar setup to an Andersen rig. I removed the sway bar bracket from the trailer frame, it was held in with 6 self tapping bolts.

Now I have 6 holes in the frame. Do I need to worry about or do anything to safeguard frame integrity at this point?

Thanks

Dave T

 

[craigav]

No, nothing needs to be done in regards to the holes. ~CA

 

[Old and soft]

I would want to get some paint on the exposed metal. Spray some rattle can primer into the cap, and use a q tip to apply to raw metal. Same for the paint after primer cures.

 

[Bugzilla46310]

I would also put bolts back in the holes to keep water from getting inside, assuming it’s a tube frame.