Apr 21, 2013 #1 EA Eagle10-JAY New Member Joined Apr 20, 2013 Posts 4 My hydra flame heater will turn on and ignite, but after heating for about 10 seconds, heat stops, then after about 10 seconds will start again. Any sugestions? Thank you.
My hydra flame heater will turn on and ignite, but after heating for about 10 seconds, heat stops, then after about 10 seconds will start again. Any sugestions? Thank you.
Apr 21, 2013 #2 Biker crd Advanced Member Joined Feb 16, 2013 Posts 37 Location Mendota Heights, MN Sounds like a bad flame sensor (thermocouple).
Apr 21, 2013 #3 OP OP EA Eagle10-JAY New Member Joined Apr 20, 2013 Posts 4 I didn't know this type of furnace had a thermocouple! This is a hydroflame 7916-II, 16,000 btu propane furnace!
I didn't know this type of furnace had a thermocouple! This is a hydroflame 7916-II, 16,000 btu propane furnace!
Apr 21, 2013 #4 Biker crd Advanced Member Joined Feb 16, 2013 Posts 37 Location Mendota Heights, MN They are the same http://homerepair.about.com/b/2009/...e-thermocouple-or-electronic-flame-sensor.htm
They are the same http://homerepair.about.com/b/2009/...e-thermocouple-or-electronic-flame-sensor.htm