nylyon
Senior Member
- Joined
- Mar 21, 2009
- Messages
- 1,127
While sitting in the campground this past weekend, I began to wonder how I was going to wire two items I am looking to do. First is to add the automatic awning retract system so the awning retracts when it gets windy and second is LED lighting under the awning.
I have measured and the current awning wiring enters the RV precisely at the bedroom door jam. I am thinking that if I could remove the jam:

I could run the wires cleanly from the outside in through the ceiling and to the control panel with the rest of the wires, but first, removing the door moulding without damaging it.... thoughts?
I have measured and the current awning wiring enters the RV precisely at the bedroom door jam. I am thinking that if I could remove the jam:

I could run the wires cleanly from the outside in through the ceiling and to the control panel with the rest of the wires, but first, removing the door moulding without damaging it.... thoughts?