tylor.pennington
Advanced Member
- Joined
- Jan 26, 2015
- Posts
- 35
I'm breaking down my White Hawk for the first time. what specifically does the low point Drain do? I have already dumped and treated my tanks. Thanks.
I want to drain my fresh water tank. Do I do that by opening the low drain point valves?
Ken
I would go ahead and empty your hot water tank. First release the pressure by pulling up on the pressure release valve. Then unscrew the plastic plug from the heater. It is often difficult to get either a rachet or channel lock pliers in there to unscrew it, but you can do it.Thanks for the advice. I opened my freshwater drain by the axle and the low point drain in the rear. Wasn't exactly sure how to dump the hot water tank so I left it alone. I'm assuming it is the white screw on cap on left side of it. I also noticed even after completely draining my bathroom grey water tank there was standing water slightly above my shower drain. How could that be with an empty tank? This was the first time we have ever used it. Hard to believe something is blocking that drain pipe already??
I also noticed even after completely draining my bathroom grey water tank there was standing water slightly above my shower drain. How could that be with an empty tank? This was the first time we have ever used it. Hard to believe something is blocking that drain pipe already??
Hair blockage or s trap sounds most logical to me. Let me clarify. The standing water was slightly below the shower drain, not above. I noticed it after a shower I took. I assumed it was because I overfilled the gray tank. And sure enough it was full. So I dumped it to empty. I look at it again. Thanks.