Need help with a part on an 08 35GS

[CAH]

The part is located on the drive side flat floor slide-out, inside on both corners. The unit is black, plastic, J shape and 3” wide. I would guess to call it a skid or guide, used to raise and lower the floor. Trying to find a name, part number, or drawing. Would also like to know if this is an easy/hard DIY change out. Just a FYI the part broke off and took out both plastic sleeve/bearings in the gear box. Thanks for any help.

 

[Grumpy]

Contact Lippert, they bought Power Gear, the company that made the slide out.

 

[Rustynuts]

Is it the wear bar along the floor that you are talking about?

RV Slide Out Wear Bars

Our slide out wear bars are low-friction and long-lasting. Every wear bar is one homogenous piece. The slick material reduces slide out motor stress by 30%.

asvplastics.com

 

[CAH]

Grumpy, will do, but I think this might be a Jayco added part.
Rustynuts, the part is only 3 inches wide and moves with the floor.
Attached is the photo of the good plastic part on the right front inside moving floor.
My broken part is on the left side under the gaucho eating setting area.
Thanks to both of you for your reply.

 

[CAH]

Update, Lippert could only find a wear bar block , Jayco ask for more photos.
The only plus was, I found out my Seneca RV seller put these on at Jayco’s request (warranty) for helping with the carpet rolling up. The part number shows to be 0501894, waiting for Jayco to respond back to RV seller. I see where the plastic slide-out edge ski are being replace with stainless steel units. My ski is flat and 5/32” thick ABS plastic. The broke off end piece show the bend around the floor plywood to be angled, could be for tracking, like a toe in or a problem. Note photo.

 

[CAH]

Jayco got back to the RV dealer with a 3 to 4 week delivery time, cost for item, freight, special order and I think tax , total $50.37. A week later they told the dealer the part was obsolete. Guess I need to learn how to cut and bend ABS plastic.