Scan D install

[Mnwelsh]

I am having a problem plugging the 9 pin connector into the diagnostic connector. Any tricks? I line everything up and push hard but it's acting like the pins are to big to fit in. Don't want to bust it

 

[Robbbyr]

My ScanGauge connection has two ways (sides) it can plug in, make sure you are using the correct side!

 

[mikew968]

just installed and it plugs right in.

 

[Mnwelsh]

Thanks for the information. The pins were very tight but I finally got it on. It would fall off with the slightest pull. Put some tie wraps on it to secure the connection and it works perfect.

 

[tjbroussard]

Installed

I ran my cable up the A pillar and made a small bracket that hangs just below the small overhead bin. Ill add a picture in a bit.

 

[BrentJ]

Would like to see your mount. I've got my tire minder up there already next to the overhead bin so was wondering about a place for the Scan gauge assuming I find value in it. I honestly think Trans temp might make it worthwhile but was looking for more "support".

 

[tjbroussard]

here you go. Aluminum angle stock.


Sent from my iPhone using Tapatalk

 

[tjbroussard]

Sent from my iPhone using Tapatalk

 

[BrentJ]

Did you fasten the angle to the bin or some of the metal behind the bin?

 

[tjbroussard]

Simple auto adhesive tape to the underside of the bin and on the gauge. Snaked the wire from behind and made a small notch on edge of headliner to accomodate the cable.