Has anyone installed the SeeLevel Tank Monitor system in a Precept 31UL? I've crawled under my RV and here's what I've discovered:
- I can access the back of the fresh water tank from way underneath the RV. I have access to the existing level sensors, however very difficult. I think I can install a SeeLevel tank monitor strip on the side of the tank and use the existing wiring.
- I can access the grey water tank by removing the shield behind the passenger rear wheels. I think the current sensors are there and I can install the SeeLevel tank monitor there also.
- The black tank; however, seems to be a REAL problem. The current sensors are 2 on the side and 2 sandwiched between the tank and the outside wall of the RV. The reason for this is because the tank is not flat on the sides so they put 2 sensors on the 'L' shaped side and the higher sensors on the front because it's flat. However, they are now inaccessible. I cannot get at those sensors also making it almost impossible to install a SeeLevel monitor strip on the front (between the tank and the outside wall of the RV). I hate to think I have to cut an access hole in the outside wall just to get access to the top of the black tank.
Any ideas?
Thanks, Val.
- I can access the back of the fresh water tank from way underneath the RV. I have access to the existing level sensors, however very difficult. I think I can install a SeeLevel tank monitor strip on the side of the tank and use the existing wiring.
- I can access the grey water tank by removing the shield behind the passenger rear wheels. I think the current sensors are there and I can install the SeeLevel tank monitor there also.
- The black tank; however, seems to be a REAL problem. The current sensors are 2 on the side and 2 sandwiched between the tank and the outside wall of the RV. The reason for this is because the tank is not flat on the sides so they put 2 sensors on the 'L' shaped side and the higher sensors on the front because it's flat. However, they are now inaccessible. I cannot get at those sensors also making it almost impossible to install a SeeLevel monitor strip on the front (between the tank and the outside wall of the RV). I hate to think I have to cut an access hole in the outside wall just to get access to the top of the black tank.
Any ideas?
Thanks, Val.
