Hello,
Did anybody change the water filter on Redhawk 24B. If yes how do you get to it? I know it behind the drawers but I can’t pull the drawers out with the limited space between bed.
Thanks in advance.
This post makes me think........Do I have an inline water filter? I use the outside filter when hooked up, and filling. Wonder if I have an inline filter like y'all talking about.
You get to it by removing the access panel by the fuse box. It will still be a sharp right turn to get to it, but the filter will be well within reach.
That's still a MAJOR pain in the butt to get to. Such a stupid place for Jayco to put it. On my To-Do list is to get in there and completely remove the cannister before winterizing.
Thank you RVlady. To be clear, you are talking about the Redhawk 24B, correct? That would make sense as the bottom drawer on the driver side below the wardrobe in the back would be right next to the incoming water. We are brand new to the forum as we just bought a 2020 Redhawk 24B. We were so lucky that it was in perfect condition and the original owners had every receipt and every manual. And it only had 6900 miles on it. Very grateful to find this forum.
Do you know where the slide drive motor(s) are?Lets hope that 24B slide stays in perfect condition and that's not why it was sold.
Do you know where the slide drive motor(s) are?
Thank you so much. The docs I got were very lacking. One doc they did include was for a Power Gear above floor slide system. I just downloaded the Schwintek in wall slide troubleshooting guide and that shows the controller and racks that I have located. Thanks again!They are Schwinteks so they are in the wall. There is a lot to learn about them so do some searches especially with the 24B floor model. It is a fantastic floor plan that is crippled with an underpowered slide mechanism for such a large slide.
Speaking of the controllers, my dealer said it or they are in the wardrobe closet behind some mysterious panel. Apparently they called Jayco and were given the info. I had the slide out yesterday, looked in the closet and didn't see anything obvious. Can you provide a little more information? Thank you and everyone else who have been posting on this issue as well as the stupid placement of the filter. And yes, I did get the drawer out with great difficulty. Insane. ArtThank you so much. The docs I got were very lacking. One doc they did include was for a Power Gear above floor slide system. I just downloaded the Schwintek in wall slide troubleshooting guide and that shows the controller and racks that I have located. Thanks again!