Window Replacement on Door

[Wheeler-JAY]

Just upgrade to a Jayco 24BH and I want to replace the frosted glass in the door. On this model, there are no screws to remove the inner window frame. Looking at the window frame, I see small openings around the perimeter of the frame, which makes me think the frame is a snap-fit. Is there a trick to getting the frame off?

 

[oldmanAZ]

Congratulations on the Jayco upgrade and welcome to the forum.


A couple of folks on this site have changed out their door windows. One of them will probably be along before too long.

 

[sundancer330]

It sounds like the newer models don't use screws, its just a press fit, easy to install but almost impossible to remove without cracking. Here is a link to a Lippert replacement on Amazon, read the reviews to see all the problems.

https://www.amazon.com/Lippert-Comp...946&sr=8-5&keywords=rv+door+glass+replacement

 

[Tunce the traveler]

I sure hope they glazed that window properly because without the screws it's not easy to check it. Mine was not glazed properly but I cought it on time ( thank you screws). If water gets in your door will rot out and same with your counter top if they don't caulk your sink properly so all of you should check your sinks.

 

[SloPoke-TC]

check out this thread... https://www.jaycoowners.com/forums/f5/seneca-modifications-39395-15.html#post693461

 

[bdreinv]

Are camper has screws, gosh how much cheaper can they get? Anyways replaced glass all windows match,took about an hour.