Hi sorry I haven't seen this until just now. I have a lot of tools, but nothing made this install easy. I'm not sure how one would get to it without either being right above or below the fastener. I managed to get some pliers on it and then ended up using a long thin prybar with a hammer to tighten in since you can't get anything else in there.

Dealer was no help as well.

Hello...
Saw your post from 2017 about the slide roller...
https://www.jaycoowners.com/forums/f...sue-50601.html

"Very long story short, I found a roller in the RV that had a nut come loose and detached itself from the slide rail. After exhaustively searching on the internets, I found it is called a "cam follower."

I see where it is missing on the rear slide of our 31FS, but the main weatherstrip is in the way of getting hand access. I'm sure I can purchase a nyloc nut for it, but not sure how the weatherstripping for the slide is attached. I don't want to rip it out, but seems like this is an important bearing/piece that needs to be on the slide. "

I have two rollers missing that I want to install....
My question is - was tis relatively easy to do your self?

Thanks

Mark