JAYCOMMAND tablet

[FireguyEd]

Yesterday I checked for app updates and saw the tablet was out of memory to install them all. I couldn’t update BMPro with out uninstalling a few “stock” apps…

Does anyone know if a memory card can be added to these tablets?

And how do you get off the cabinet to add/check it? Ours is in a 319MLOK.

[FireguyEd]

Nobody?? I can't be the only one that can't update the app???

[Camperdude]

I'll take a look at mine. I haven't been sent an update to my knowledge.

[ChiefCamper]

Take it off the wall and wait till it dies, then put it back on, it probably just needs to be reset. I think the latest update is dated last May, it takes about 15 minutes for the entire firmware download/update.

[JB13502]

Originally Posted by FireguyEd

And how do you get off the cabinet to add/check it? Ours is in a 319MLOK.

Should just be velcroed in place

[nylyon]

There is a bug with the version you have. Follow these instructions to clear the data then install the update.

https://teambmpro.com/wp-content/upl...g-App-Data.pdf

[nylyon]

Originally Posted by FireguyEd

And how do you get off the cabinet to add/check it? Ours is in a 319MLOK.

Gently pull the bottom corners of the controller, it will unclip then you can remove it.

[FireguyEd]

Ok, so I gave it a tug and it popped off. For anyone who may want to take theirs off, push down from the top then pull the top out…

You can put an SD card in, but a FB user group showed that going into Setting and Storage you’ll find an option to get rid of junk. That cleared up more than half my storage and allowed the apps to update.

[nylyon]

Follow that linked document also, it’s important after the update to clear the memory from the app.