Originally Posted by klassic
Curious... Where did you run your wires?
My Grandson helped me I mounted the camera right above the center light with the bracket resting on the light frame to help support the weight.
I drilled two holes thru back wall and TAPPED the holes for 1/4 thread (Engineer from work told me this was much stronger then regular screws)
I used silicone on threads and around bracket also.
Then I ran the wires straight up behind camera to trim on top carefully installed wire into channel and put trim back.
Then over to the side trim attached the connection for the TV wire it says it is waterproof connection. But I added heat shrink and same tape also. It is exposed only at the top corner and is not very noticeable.
Then into the trim molding going down the side and out the bottom and into the existing wire harness under the trailer to the front.
Had plenty of wire I took the extra wire and looped it in the Aluminum battery box and mounted the umbilical on the front of the box.
It really was easier then I thought it would be. I am extremely happy with it and the monitor supports three cameras also.
I also mounted a small camera on truck to see the ball works great just switch the view.
Hope this helps!