MCD manual shade on 2017 Jayco Pinnacle

[CapeCodGuy]

Does anyone know how to remove a manual MCD Shade on my 2017 Jayco Pinnacle and install the new one?

The original shade was pulled down to far and will not re coil so Jayco sent me a new one

[TexasRT]

If I remember correctly there are two clips that the shade housing snaps on. Look up to the shade base with a flashlight you should see them on the back, I believe you can un-clip / release them with a long screwdriver. It may be easier to remove the window valance also.

Hope this helps.

[CapeCodGuy]

We tried to unclip it but the space was to tight with the valance!

[TexasRT]

Remove the valance. it's probably a couple of small screws

[CapeCodGuy]

Where are the screws located for the valance? Do you happen to know?

[TexasRT]

Originally Posted by CapeCodGuy

Where are the screws located for the valance? Do you happen to know?

They are up inside the valance, mine has a little bracket on each end that mounts them to the wall. You have to look up inside the valance itself.

[Moparmisty]

We had the same problem with one of ours on a North Point. Husband had to remove the two little screws (Pain in the B***) to remove the blind. New one works well and once he had the old one out, he repaired it and so now we have a spare.