Reset Zero Point: Ground Leveler System

[Bauernfeind]

I've been through three leveler control panels and two broken front jack screws in less than a year with my 2016 jayco Pinnacle, all products made by Lippert. I've also had a slide malfunction and an axle bearing meltdown all Lippert Products. I too have driver's side leveling issues where when the auto level system works it still leans a few degrees to that side. How do I reset the zero point?

[rodro123]

If it's the BAL system. Use manual adjustment and a hand held level. Once you set it correct it will remember the next time you use Auto button. It's a smart system.

[Mopar_Earl]

You have to use the Lippert instructions to set the level calibration. No, it won't remember once you set it. You have to manually level it and than set the zero. It use to be hit the up arrow so many times and than the down arrow so many times. I don't recall.


Earl

[BigJohnD]

Not sure on the newer ones, but I think on the level up I had in 2014 it was up button 10 times, down button 10 times and this put you in recal mode. Manually level then and save. Of course it'll screw up a few levels later. I just did manual all the time.

[Rustysocket]

It's just not that hard to go to Lipperts website and find the manual for your specific system. The first link is a screenshot of the instructions for the Groundcontrol 3.0 system

http://www.jaycoowners.com/forums/f6...tml#post527083

Lippert Components the leading OEM and Aftermarket RV Parts and Accessory Supplier

[merlinhomeauto]

Just reset mine this weekend. Put in manual mode then level, turn off, push up arrow 10 times then down arrow 10 times after screen says calibrated push enter.