Reset switch for stabilzer

[tntnardo]

My rear stabilizers keep losing power when I retract them After a short-time they will then again retract. The issue appears to be the 20 amp auto reset switch. I have a circuit board located in my storage compartment. The switch is on that board. The problem s the reset switch (all of them) are "molded" to the circuit board. So you just can take the switch out and replace it as it appears to me. Wondering if anyone has had any experience with this. It appears that a $20 reset switch not being able to replace alone means the complete circuit board as well as all the switches would have to be replaced. Can only imagine the cost of that!! I've attached some pics of board and switch
Attached Thumbnails

[tntnardo]

Well just heard back from Jayco for $10 part that is bad on the circuit board I need to purchase the complete circuit board .. $716.00 .. Thats crazy!!

[AKRUEBBE]

Originally Posted by tntnardo

Well just heard back from Jayco for $10 part that is bad on the circuit board I need to purchase the complete circuit board .. $716.00 .. Thats crazy!!

Is it soldered to the board? If so, I'd try to locate that part and take the board and part to someone that can swap them out.

[tntnardo]

Thanks for the reply. Once I get home end of April I'll try and do something like you suggested or try and run a new wire back to the switch with a inline fuse so I could then bypass the faulty switch.

[Dr.Green]

I have the Stabl-lite system with two Stabilizers that pop down.
THe extended light is on with the Stabilizers retracted.
the manual states that there is a Fuse (40) amp - I can't find it anywhere.

I don't think it is a fuse as the Extended light is on?

Is there a reset button in this module as well?


Bryan