23B Gate valves

[Midwest5]

Going to tell on myself here a little bit. The last camping we took in 20 I managed to bust my gate valve for the grey tank while we were packing up. I pulled forward to get my leveling boards from under the tires and when I did the board popped up and jammed up right into the valve handle. Needless to say I will be revamping my leveling boards. So my question is does anyone happen to know the size of the grey water gate valve off the top of their head? I hoping to save a trip out to where it's stored at. Any info would be appreciated, thank!

[Lselliott]

I believe it’s 1 1/2” I’m thinking they are standard 3” for the Blackwater and 1 1/2” for grey.

[Midwest5]

Originally Posted by Lselliott

I believe it’s 1 1/2” I’m thinking they are standard 3” for the Blackwater and 1 1/2” for grey.

Ok, thank you.

[Jagiven]

Mine is still is still unaccessible in winter hibernation for another week. The grey water does use a smaller pipe. Only two sizes I am familiar with is 1.5" and 3" so you should be fine with ordering a 1.5" gate valve.

[Midwest5]

Originally Posted by Jagiven

Mine is still is still unaccessible in winter hibernation for another week. The grey water does use a smaller pipe. Only two sizes I am familiar with is 1.5" and 3" so you should be fine with ordering a 1.5" gate valve.

Thank you. We are in the situation with storage. Hoping within the next 2 weeks mine will be back home again

[Jagiven]

The grey water on mine is a "Valterra 1 1/2" Bladex Valve". Here is a couple image too.





Hope this helps

[Midwest5]

Originally Posted by Jagiven

The grey water on mine is a "Valterra 1 1/2" Bladex Valve". Here is a couple image too.

Attachment 70033

Attachment 70034

Hope this helps

Thank you. So I broke mine off at the handle and top part where the valve blade slides up into, do you know by chance if you can unbolt it and just replace the center section with the handle and valve in it and not have to replace it as one whole assembly? Im hoping i can and dont have to cut it out and repipe one in.

[Grumpy]

Originally Posted by Midwest5

Thank you. So I broke mine off at the handle and top part where the valve blade slides up into, do you know by chance if you can unbolt it and just replace the center section with the handle and valve in it and not have to replace it as one whole assembly? Im hoping i can and dont have to cut it out and repipe one in.

You can buy the blade assembly that just bolts in.