7 pin connector for Toad

[rgolding]

I guess I had the Towing Harness too tight and pulled the 7 pin connector out of the socket going down the road. Long story as to how it might have happened. Does any one have the wiring diagram for this? Little shy about hooking brakes up wrong. All help appreciated. Yes, its raining.

[Jagiven]

I have not wired a Toad, but the wires in the cord are the same.

Here is a 7-pin wire harness

[jd99336]

The wiriing of a 7 pin is standardized now, so when I wired my toad, I simply googled it and then tested it before my final wiring.

If you have a test light or multi meter, take the diagram provided by Jagiven as an example then simply test each wire to confirm it. Even if you can't get them all you should easily eliminate each wire (L Turn, R Turn, Driving, Hot, Grnd) leaving you with few questions. Just don't touch the wires together or to ground.

You should do this anyway in case you blew a fuse or two when it ripped out. That is a possibility, so you will be wondering why things aren't working. Also, in case you actually damaged a wire in the process. Could save you some grief.

[rgolding]

Thank you for the responses. It pulled out of the Seneca, complete plug before it started dragging, so don't think the fuse blowing is a problem. No electrical to anything, while dragging. Problem is Seneca of end to harness plug was damaged and only 2 of 6 wires were left connected and the 2 were not in the marked/color coded locations. i remember there was questions when it was hooked up. This is the second vehicle wired to this harness. Biggest problem is blue (brake wire) is shorter and looked like it pulled out of big center plug (normally back up lights). I'll get it, just looking for a SHORT CUT. Yes, I should have made a diagram and will when I get this worked out.

[rgolding]

Originally Posted by Jagiven

I have not wired a Toad, but the wires in the cord are the same.

Here is a 7-pin wire harness

Attachment 49957

This wiring diagram proved to be correct for our 2015 37FS. Took me awhile to get it resolved, because of other commitments. Thank you for providing.

My towing wiring harness now has a small shock cord at each end, so that if it ever gets pulled out, again. It will not fall to the ground and drag. Also have a paper copy of this wiring harness in the tool box of both ends of this harness.

Another lesson learned.

[ChuckW]

https://www.roadmasterinc.com/pdf/85-4959.pdf