Leveling Jack Issues and Solutions

[northrupj]

Just done with my second shakedown cruise in a 2015 Greyhawk 29MV and the only issue of note was with the self-leveling jacks.

Mark me down as technologically illiterate, so if I sound stupid I am.

The first time I lowered the jacks, I did it without pressing the System Power button first. Lo and behold they lowered and eventually stopped adjusting. And lights were flashing everywhere. I couldn't raise them until I noticed the emergency retract button. Pushing that did the job. Still flashing lights like mad and no response when I pushed the auto level button.

Some research showed me what to do. I had to find a screwdriver with a square head, remove the panel, unplug the wires then plug them back in. After reading the instructions I realized I needed to push that system power button before I did anything else. No problems since then.

This is intended as a cautionary tale for other newbies. No criticism of the leveler at all. They work exactly the way they're supposed to, as long as you follow instructions.

[Grumpy]

Originally Posted by northrupj

They work exactly the way they're supposed to, as long as you follow instructions.

Instructions, what are those?

[Jopopsy]

Check the level of your unit w/ a actual level on the counter by the fridge. Mine worked, but it as not calibrated right. Easy fix per the manual.

[cbss]

Check this out....
http://thebigfootleveler.com/uploads..._Manual_v2.pdf

http://thebigfootleveler.com/Installation_Manuals.html

[northrupj]

That's exactly the manual I found that taught me how to use the things.

[WDW]

2x on calibration. If it's new, make it a point for your service appointment and watch them do a system reset. That way you can do it on your own if necessary. That's how I learned it.