2015 Seneca Bigfoot system power

[Life on the Verge]

Two lights flash on the levels and the all up light is lit. The emergency retract works, but the system power will not come on thus the levelers aren’t working. My RV batteries did get dangerously low but we’ve been on shore power for 20 hours. Is here a reset of some sort? Never had a problem before.

[Robbbyr]

Originally Posted by Life on the Verge

Two lights flash on the levels and the all up light is lit. The emergency retract works, but the system power will not come on thus the levelers aren’t working. My RV batteries did get dangerously low but we’ve been on shore power for 20 hours. Is here a reset of some sort? Never had a problem before.

First, do you do have the chassis ignition "off"? It won't work with the ignition on.

To "reset" the Bigfoot system you can do it one of two ways. You can remove the control panel from the housing and unplug the wiring harness from the back of the panel for 30 seconds or so then reconnect.

Secondarily you can disconnect the wiring harness from the Bigfoot control module itself. My module in my TS is located in the bottom of the cabinet just inside my entry door where all of the controls are located. In the lower cabinet (under the bottom panel) screwed down to the actual coach floor is the main control module. Disconnect the wiring harness, reconnect after 30 seconds.