I've been doing a good number of modifications and upgrades to the BMPro/JayCommand system in our 24BH these last few weeks. I concur with the above statement: it sounds more like a wiring problem than a controller or node problem.
Before you go that far though, open the JayCommand app and then go to Settings. Scroll down to and open "About SYSTEM" and confirm that the model number programmed into your controller is the same model you own.
It will probably be a PITA, but you'll need to pull down the areas where the wires are run and trace out the circuits. Most likely there are some miswired or loosely connected WAGO wire splices on your circuits.
If you need more of the factory-style connectors, you can find them here and on Amazon:
https://www.wago.com/us/discover-wir...ing-connectors
__________________
2014 Ford F250, 6.7 diesel, 4X4, short bed
| Weigh Safe weight distribution hitch 2.5" shank
| 2021 Jay Feather 24BH
HAM - KN4OLA
Wondering what your Jayco VIN means? Check out my
Jayco RV VIN decoding thread.