A Frame 12 HMD wired for fantastic/Vent

[ddowell73]

Hello everyone!
I recently bought a 2015 Jay Series Sport 12 HMD "A Frame" Pop Up. I am considering replacing the standard vent with a fantastic fan Powered Vent. The Powered vent was available as an option for this model. What are the chances there will be a "fantastic" wiring harness already installed when I remove the standard vent, making for an easy and clean looking install?

Dave

[Sundancer330]

I have a 12 HFD and wanted to do the same. I contacted Jayco and they sent the drawings for the electrical and no such luck, unless the fan option was ordered they only installed the static vent with no power. I looked at one at the dealer to see where they pulled power, if you look inside under the valance on the front drivers side you will see 12v wires for the light on the roof panel. If its wired for the fan you will have two sets of wires going into the roof, mine only had one like the drawing showed.

[ddowell73]

Thanks Sundancer
This is great info. I am still going to install the fan, but now I know how to tell if I am pre-wired or if I have to get creative in running them without it looking too bad.

[Sundancer330]

I was going to use wiremold channel and run it up the roof panel right next to the side panel to conceal the wires. But after using the TT several times I only opened the vent on very hot days a few times to help exhaust heat up near the peak when the A/C was on. I decided it wasn't something that I really needed.

https://www.amazon.com/Wiremold-C10-...words=wiremold