|
10-10-2012, 01:21 AM
|
#1
|
Junior Member
Join Date: May 2012
Posts: 13
|
Furnace cycling issue (x213)
I just had my 2012 x213 in to be service and winterized. It had developed a few problems this year: the rear slide sounded like a heard of banshees and the furnace was constantly cycling on and off.
They fixed the slide (said the bolts were loose and was slightly of the tracks). For the furnace they said there was no problem and that it was from a low battery. The problem was that the furnace would come on, with the blower, then you would hear the propane firing for a few minutes, shutting off, then firing again, while the entire time the blower would run. The atco furnace manual says see the dealer if this happens, so I did.
I called BS on their 'findings'. Primarily because it was plugged in during the last time this happened (so it should be bypassing the battery, plus the blower was on the entire time). They then tried to blame it on the propane gauge being shut off. Derp derp. I un-politely reminded them that I did not materialize the trailer into their shop, but towed it in and in doing so shut off the propane tanks.
They insisted it was the battery. I left.
Any ideas?
|
|
|
10-10-2012, 03:50 AM
|
#2
|
Senior Member
Join Date: Jun 2011
Location: Kalamazoo, West Michigan
Posts: 1,817
|
Sounds like the burner was short cycling because it was tripping an over-temperature limit on the heat exchanger. When the blower cooled it off the burner would fire up again. Is the return air opening free and clear and are all your registers wide open?
__________________
2006 23B Hybrid with 10k round bar WDH
2011 F150 4x4 SCREW Ecoboost, Max Tow, Integrated TBC, 3.73 LS axle, Firestone Ride Rite airbags.
|
|
|
10-10-2012, 04:31 AM
|
#3
|
Senior Member
Join Date: Jun 2012
Location: Sparta, TN
Posts: 1,174
|
It is NOT the battery. I would say you need to find a dealer that knows what he is doing. This one obviously does not.
__________________
Chuck - Sparta, TN
2012 Jay Flight 22FB, 2 x Honda EU2000i
2013 GMC Yukon XL Denali AWD
EDUCATION is what you get when you read the fine print.....
EXPERIENCE is what you get when you don't.
|
|
|
10-10-2012, 11:00 AM
|
#4
|
Junior Member
Join Date: May 2012
Posts: 13
|
All the vents were cleared from any air blockage.
I agree this is not a battery issue....and this dealer has no idea what they are doing.
|
|
|
10-11-2012, 06:03 AM
|
#5
|
Senior Member
Join Date: Jul 2012
Location: Fulton, NY
Posts: 958
|
I would pull the whole furnace assembly out and open it up myself. There is probably debris blocking the firing chamber or the oriface is partially plugged. I helped a buddy of mine this summer pull his furnace out and we found a piece of rust in the oriface keeping it from firing.
Of course being a new unit, I would find a better dealer to do business with. They should be fixing this under warranty for sure.
__________________
2017 28BHBE Kitchen skylight, remote control and Aluminum wheels hitched by ProPride 3P
2017 Ram 2500 CC LB 4x4 Big Horn Cummins
|
|
|
12-08-2012, 09:52 PM
|
#6
|
Junior Member
Join Date: Jan 2012
Posts: 25
|
Check for a flame sensor. Electronic ignition has a safety which gets a white coating on it and does not make a strong enough signal back to the gas valve. The flame will come on for 2-5 seconds then off. Then cycle again. I imagine there is no ignition board on these small furnaces.
|
|
|
12-09-2012, 01:16 AM
|
#7
|
Junior Member
Join Date: May 2012
Posts: 13
|
thanks, I'll be checking this once its spring and replacing if needed.
|
|
|
12-09-2012, 05:40 PM
|
#8
|
Senior Member
Join Date: Feb 2012
Location: Richmond B.C.
Posts: 303
|
Hmmmm...I too had an issue and it affected the fridge as well..I switched the propane switch valve to he other ank and it worked.
__________________
2012 Jayfeather X213
2004 Dodge Ram 1500 Laramie Quad cab 4x4
|
|
|
12-10-2012, 09:46 AM
|
#9
|
Senior Member
Join Date: Jun 2010
Location: Saskatoon Sask Canada
Posts: 10,726
|
Call Jayco and ask them to recommend a different dealer in your area... That will 1) get your furnace fixed and 2) get Jayco looking at that dealer as he is not doing them any favors...
__________________
Seann
2004 Chev Silverado Duramax optioned past the max. 2009 Jayco Eagle 308 RLS 900watts of solar, Lithium batteries (400amp hour), 2000 watt (4000 surge) whole house inverter.
145days /2023 2022/151 2021[/COLOR]
93/2020,157/2019219/2018 206/2017,215/2016, 211/2015, 196/14, 247/13, 193/12
|
|
|
12-15-2012, 11:13 PM
|
#10
|
Senior Member
Join Date: Sep 2012
Location: Greater Detroit area
Posts: 146
|
this problem defitnetly sounds like a flame sensor Had a old style hot water tank that would have that kind of problem
|
|
|
12-30-2012, 06:09 PM
|
#11
|
Junior Member
Join Date: Jan 2012
Posts: 25
|
Flame sensor
The sensor can be pulled and cleaned with an Emory cloth or a fine nail board the Mrs. Might have. Because no pilot light this is a safety.
|
|
|
01-12-2013, 01:36 PM
|
#12
|
Senior Member
Join Date: Jan 2013
Location: northern Il.
Posts: 138
|
Had this problem last year. Ignitor, even though you hear it clicking can be bad. It sends a signal to the board telling the board a flame is present and to allow the gas valve to stay open. Sail switch in air stream which must be free and open and close tells board the blower is working also. Ignitor replacement is a real pain to get at. You need the furnace out and on a bench where you can split it in half
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|