The wall panel in the shower is bowing out on the side. I suspect if I razor knife the silicon bead on top, it will lie flat again. The question is what is the best kind of adhesive to bond the panel back to the wall.
I’m not sure if your shower is one of the type that was discussed in a thread about the shower walls and whether they were supposed to be free of seal to allow moisture to escape from behind the shower wall. You may want to check with Jayco before you make modifications to the shower.
The wall panel in the shower is bowing out on the side. I suspect if I razor knife the silicon bead on top, it will lie flat again. The question is what is the best kind of adhesive to bond the panel back to the wall.
Who put the silicone on the top? That is supposed to be open, as CAG mentioned, to let any moisture out. The factory used to use 2 sided tape.
DISNEY LOVERS
Linear Mode
