2020 Precept 31UL Autogen question (I think ;-))

[hartlenb]

We bought our RV used from a camper dealer so no help from them. Can anyone tell me what the reset button on our command panel does? It seems to be part of the AutoGen but the documentation I found on the Autogen (Magnum ME-AGS-S) has no reference to a reset switch.

[mkassab]

Originally Posted by hartlenb

We bought our RV used from a camper dealer so no help from them. Can anyone tell me what the reset button on our command panel does? It seems to be part of the AutoGen but the documentation I found on the Autogen (Magnum ME-AGS-S) has no reference to a reset switch.

Googled manual.... see attached.
In the Jayco user manual is says:
" The RESET switch will disable the AGS system. The ENABLE and STATUS indicators will go off and the generator ( if running will shut off )."

"Disengaging the parking brake and turning on the ignition will disable the AGS system if it was previously enabled. To reset it again, the parking brake must be set and the ignition turned off. The ENABLE switch on the command center panel must be selected again to put the system in automatic start mode."

Hope this helps.

Mark

[hartlenb]

Thanks - never thought of looking at my Precept manual.

[ladder16]

Thanks for posting the pdf Mark. It is very helpful. The Jayco manual only has 1 page on the Autogen.

[hartlenb]

Here's a link to a newer version of the manual (from 2016). Note that it does not reference the reset switch that started this discussion.