Breaker or fuse for Sani-Con on 37MDQS

[Moseh]

Can anyone tell me where to find a breaker or fuse for the Sani-con. It doesn’t seem to be getting power. Don’t see a fuse or breaker in the main panel.

[Cincinnati Kid]

Looks like you have a 35 amp inline fuse. I imagine you will see it if you open the coroplast near the pump.

[Moseh]

Originally Posted by Cincinnati Kid

Looks like you have a 35 amp inline fuse. I imagine you will see it if you open the coroplast near the pump.

Attachment 77423

Thank you! I’ll try that tomorrow!

[Cincinnati Kid]

Originally Posted by Moseh

Thank you! I’ll try that tomorrow!

Might be in or behind the switchbox- but it must be close to the motor somewhere, according to the manual.

[AKRUEBBE]

Originally Posted by Moseh

Can anyone tell me where to find a breaker or fuse for the Sani-con. It doesn’t seem to be getting power. Don’t see a fuse or breaker in the main panel.

There is a relay switch that may be bad. It is located, of all places, on the floor behind the water panel. There have been post that a slight leak can drip on it and cause it to corrode.

[rgardjr]

Originally Posted by Moseh

Can anyone tell me where to find a breaker or fuse for the Sani-con. It doesn’t seem to be getting power. Don’t see a fuse or breaker in the main panel.

I have a different trailer, but the relay for my Sani-Con was attached to the back of my power converter. Not sure where the fuse is located, but relays can also go bad.

[Moseh]

I replaced the relay with no success. I opened up the bottom and checked all around Sani-con unit. No fuse (there is supposed to be a 35 amp somewhere). Guess I’ll have to break down and send it to dealer maintenance hell…