|
If its not doing anything, sounds like no power at all.
The fuse for the slide should be on a 30amp auto reset breaker in the panel that has all the rest of your breakers based on my wiring diagram (2018 Greyhawk). Mine is on the foot of the bed. On the same 30 amp is also one of the tank heaters. I'd be curious if you try turning on the tank heaters if the light comes on. If it doesn't, it could be a bad auto reset breaker. Hopefully your fuse panel is labeled.
Both slides have auto reset breakers. If they are the plug in kind and you see both on the panel, you could swap as well and see if the issue follows the breaker.
Other than that, you'd probably need a multi-meter and start looking where power is lost from the breaker to the slide motor. Your wiring could be a little different, but generally they are close to the same from what I've seen.
I suppose you could disconnect all power for 3-4 min (shore and battery) and see if that causes anything to reset as well. I doubt it, but easy test.
Attaching a few diagrams for reference.
__________________
2018 Jayco Greyhawk 31FS
2023 Wrangler 392
|
Linear Mode
