In wall slide roller - fixes

[hymanykd]

So when my outrigger bent it looks like it took one of the rollers with it, looks like the shaft most bent as the front metal edge is now gouging the floor up. Figure I can take a jack from the bottom and lift the weight off the roller go inside and unbolt the roller and push a new bolt in. Can anyone tell me what type of roller, the dimensions I see there is either a 1 1/16 or a 1 3/8 and the bolt size and length?

[hymanykd]

Here’s a picture

[hymanykd]

Just finished up. Looks like when the out rigour bent it took the roller bolt with it the roller bolt was bent almost a quarter of a inch to change the bolts I cut two wedges and where And wedge them under the floor and bolted the roller change the bolts and slid a piece of 24,000s of an inch metal for the roller to slide on

[hymanykd]

Here is the bolt 3/8 x 5lg